THIS PROCESS IS BEST ACCOMPLISHED BEFORE INSTALLING THE FOLLOWING BUT CAN BE DONE, WITH GREATER DIFFICULTY, WITH THE BELOW MENTIONED COMPONENTS INSTALLED!

  Radio

Glove box Liner

Defroster Ducting

 Under the dash, attach transmission cables to auxiliary drive drums “A” and “B” as follows;

Attach right (Passenger Side) cables to drum “A” in the following sequence:

a)      Cable #1 (Cable leading from top of transmission pulley) to retainer No 1.

b)      Cable #2 (Cable leading from bottom of transmission pulley) to retainer #2.

 NOTE: Right transmission cables should “Cross-over“ each other approximately midway between the transmission and auxiliary drive.

 Attach left transmission cables to drum “B” in the following sequence:

 (a)    Cable #3 (cable leading to top of transmission pulley)

(b)    Cable #4 (cable leading from bottom of transmission pulley)

 NOTE:  Left transmission cables do not cross over.

 Adjust cables to tensioned position.

Connect wiper motor parts as required and check operation of wiper motor.  Install instrument panel compartment box.